Re: Отремонтировать KMVWU000LM-B900 NAME: 00000 ?
#6
Попробовал
Stage 2 не проходит:
Код:
Z3X EasyJtag Software ver. 1.5.7.0
Loading eMMC Addon Firmware... IO: 1850 mV
FW Ver.: 01.50
CMD Pullup Level:1959 mV
CMD Active Level:1907 mV
eMMC Device Information
EMMC CID : 1501003030303030305620110726589C
EMMC CSD : 902701320F5903FFF6DBFFEF8A404022
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 05/2005 Rev.0x56
EMMC NAME: 000000 , S/N: 537986854
EMMC ROM1 (Main User Data) Capacity: 32768 MB
EMMC ROM2 (Boot Partition 1) Capacity: 512 kB
EMMC ROM3 (Boot Partition 2) Capacity: 512 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
Backup saved: 000000_ 537986854_20140604_2034.extcsd
Done.
Running:SAMSUNG: MoviNAND VTU00M Name 0000 Repair...
Z3X EasyJtag Software ver. 1.5.7.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1959 mV
CMD Active Level:1907 mV
Repair VTU00M eMMC:
Entering repair mode 1...
Success
Erasing repair area...
Success
Writing repair area...
Success
Exit repair mode 1...
Success
===================================
NOTE: This stage was reapir only eMMC NAME , not wear leveling data!!
NOTE: Repair Stage 2 must be done to make eMMC repair completely!
Please, Reconnect eMMC power lines and press 'VTU00M Repair' again
===================================
Running:SAMSUNG: MoviNAND VTU00M Name 0000 Repair...
Z3X EasyJtag Software ver. 1.5.7.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1959 mV
CMD Active Level:1907 mV
ERROR: This eMMC are not VTU00M!
===================================
Детект eMMC проходит, но ремонт имени уже нет:
Код:
Z3X EasyJtag Software ver. 1.5.7.0
Loading eMMC Addon Firmware... IO: 1850 mV
FW Ver.: 01.50
CMD Pullup Level:1959 mV
CMD Active Level:1907 mV
eMMC Device Information
EMMC CID : 15010056575530304DF04C1764625FA4
EMMC CSD : D02701320F5903FFF6DBFFFF8E40406C
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 05/2012 Rev.0xf0
EMMC NAME: VWU00M , S/N: 1276601442
EMMC ROM1 (Main User Data) Capacity: 29820 MB
EMMC ROM2 (Boot Partition 1) Capacity: 2048 kB
EMMC ROM3 (Boot Partition 2) Capacity: 2048 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x01 , width 4bits , Partition config [179]: 0x48.
Backup saved: VWU00M_1276601442_20140604_2037.extcsd
Done.
Running:SAMSUNG: MoviNAND VTU00M Name 0000 Repair...
Z3X EasyJtag Software ver. 1.5.7.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:1959 mV
CMD Active Level:1907 mV
ERROR: This eMMC are not VTU00M!
===================================
Последние файлы
