Infinity Chinese Miracle-2 MTK/Mediatek v2.10 - New MTK chips and UFS storage
#1
Infinity Chinese Miracle-2 MTK/Mediatek v2.10 - New MTK chips and UFS storage
Core
NewChip: Helio G90T (Formely MT6785) supported (UFS / eMMC)
NewChip: MT6731 supported (eMMC / NAND)
NewChip: Helio A20 (Formely MT6761 low-cost revision) supported
NewChip: Helio P90 (Formely MT6779) support under test (UFS / eMMC)
BugFix : MT6595/MT6597 BROM support broken, fixed (Agent 17xx-19xx)
New Feature : UFS FlashIC support
!* Support flashing Factory / Infinity FW
!* Support MemoryTool
!* Support Factory Firmware reading
!* Support Service operations
!* SOC's on market, support UFS chips right now : G90, P70, P90
Service
Changed : Repair security procedure updated (Flash and Meta mode)
Changed : SPUnlock procedure updated (Flash and Meta mode)
Changed : Identify procedure updated
Changed : Format FS / Reset FRP now support UFS flash too
New Feature : Modem Re-Init (NVfix)
!* Useful after FixBB, in case of modem subsystem alive
Firmware Reader
New Feature : UFS flash support
New Feature : Combo scatter creation for newest chipset
!* Produced scatter MAY NOT work with OLDER SPFT (factory flasher) below 19xx versions!
!* Produced scatter is 100% like factory ones
Changed : Improved structure identification
Changed : Support more different types
Changed : NAND support revised
Changed : LEGACY line support revised
Changed : Platform and version depend scatter creation for better compatibility with SPFT
Changed : LEGACY line with Android 9 (MT6580 and similar) specific changes
MemoryTool
New Feature : UFS flash support
!* Support Read , Write , Erase partitions
!* Support RePartition
!* Support Preloader init
!* Support Change Work mode (ADR / PRT)
!* Change storage settings useless, all flash content mapped in single mode
Changed : Structure identification
Changed : Automatic files selection at folder change
Flasher
New Feature : Support COMBO scatter's (v2.xxx)
!* Automatic selection depend on device Flash (UFS/EMMC/NAND)
!* Storage selection done automatic according detected, for end-user all selection and rest settings remain same as before
New Feature : Support MTK chips with UFS FlashIC flashing
!* All features (Erase / Verify / PMT upgrade / Backup / HW Compatibility) work for devices with UFS as well
Changed : Scatter tab changes, specific to multi-storage selection and settings
Meta protocol functions updated
Changed : Updated security detection feature
BugFix : Updated structure verification
Other
BugFix : A lot of minor changes and bugfixes applied
Changed: Many internal changes to improve compatibility with other applications, antiviruses and similar software.
Changed: Software load/operation speed improvements implemented
https://www.infinity-box.com/news/?r=3998