Z3X EasyJtag Software ver. 2.5.0.9
Loading eMMC Addon Firmware...
IO: 3300 mV
Box S/N: 01FFD010*******, ,FW Ver.: 01.58
CMD Pullup Level:1928 mV
CMD Active Level:2588 mV
Box IO Level:3300 mV
CLK Rate:14000 khz
HiPower mode is ON!
---------- eMMC Device Information ----------
EMMC CID : 1501004D384732464208D00E6E8A11E0
EMMC CSD : D02701320F5903FFF6DBFFEF8A404066
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 01/2014 Rev.0x8
EMMC NAME: M8G2FB , S/N: 3490606730
EMMC NAME (HEX): 4D384732464200
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 2048 kB
EMMC ROM3 (Boot Partition 2) Capacity: 2048 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x03
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: M8G2FB_3490606730_20170429_1403.extcsd
---------------------------------------------
Done.
Z3X EasyJtag Software ver. 2.5.0.9
Skip loading eMMC Addon Firmware
CMD Pullup Level:1928 mV
CMD Active Level:2588 mV
Input file : C:\Users\shoxa907\Desktop\Новая папка (3)\P3100_Main_BN.bin
Writing 0010000000 bytes to 0000000000... ROM1 (USER ROM)
Retry writing adress 0x0000000000 (Attempt #0)...
Retry Fail!
Retry writing adress 0x0000000000 (Attempt #0)...
Retry Fail!
Retry writing adress 0x0000000000 (Attempt #0)...
Retry Fail!
Retry writing adress 0x0000000000 (Attempt #0)...
Retry Fail!
Retry writing adress 0x0000000000 (Attempt #0)...
Writing flash page stopped by user request
Done.
[свернуть]