MAUI : RM-1011_ROM_eMP_30.06.11
VIVA : RM-1011_VIVA_eMP_30.06.11
LANG : RM-1011_LANG_PACK_ROM_EI_eMP_30.06.11_001
CUST : RM-1011_CUSTPACK_ROM_EI_EURO_RU_eMP_30.06.11_001
JMPT : RM-1011_JUMP_TABLE_EI_EURO_RU_eMP_30.06.11_001
- > MODE : FullFlash

Dead Mode is Selected
Waiting for USB device...
1. Phone should be Off!
2. Battery must be charged and inserted! ( if not used external power )
- > If phone can't switch to BL - use battery or flash from Local mode!

--- Insert USB cable now! ---
Wait for phone...
Phone found! [ 8 ]
Sync...
Sync Ok, read regs...
Inital regs read done
Boot Info :
BB_CPU_ID : 6260
BB_CPU_HW : CB00
BB_CPU_SW : 0000
BB_CPU_SB : 8000
BB_CPU_NM : [MediaTek] MT6260_S0001
BB_CPU_SN : 57A5D2DCC9F39C5CA03F6323C0E7DD4D
BROM Protocol Version : 05
BROM Status : 0000
Comm Status : 0000
EXBL Status : Alive [ USB Load Active ]
Switch to BL failed! (CMD not accepted, 0xAA)
Check Power / Cable!
BootLoader Init Failed (HW/Connection Error)
Connect phone on selected interface...

Boot Error

Wait for phone...
Phone found! [ 8 ]
Sync...
Sync Ok, read regs...
Inital regs read done
Boot Info :
BB_CPU_ID : 6260
BB_CPU_HW : CB00
BB_CPU_SW : 0000
BB_CPU_SB : 8000
BB_CPU_NM : [MediaTek] MT6260_S0000
BB_CPU_SN : 57A5D2DCC9F39C5CA03F6323C0E7DD4D
BROM Protocol Version : 05
BROM Status : 0000
Comm Status : 0000
EXBL Status : Alive [ USB Load Active ]
Switch to BL done
BL Version : 01
Setting...
Setting done , result code 0x8000
BROM stage done
Seek and prepare DownloadAgent
DownloadAgent matching HW Found!
DA verify and select done
Sending DA to target ...
DA_eMP_NkP.fg
DA_INFO : 0xC0 , Ver : 3.2 , BBID : 0x8B
DA_CSTAT : 0x5A
SOC_VERIFY : 0xC1
BOOT_STYLE : SF_FLASH_BOOT
NOR Flash IC initialized
[0] : FLASH_VEN : 0x00F8 , [WINBOND] W25Q128FW
[0] : FLASH_DIE : 00EF 0060 0018 0000
[0] : FLASH_LEN : 0x01000000

Executing FFS FORMAT now...
FAT_RANGE : 0x00C80000-0x00FF3FFF , LEN : 0x00374000
DA_RET : DA_IN_PROGRESS
DA_RET : FORMAT_DONE

Done!
Elapsed: 00:00:43
Reconnect Power/Cable!

Finish at : [12.04.2016 / 16:17:01